Check for update details in the Firmware History located at the top of the 
firmware download page (located on the TSC website).

Ensure that firmware from only one product code is loaded on the SD Card.
	
EXAMPLE
	Correct: 	romdata (folder)
				B222 (folder)

	Incorrect:	romdata (folder)
				B222 (folder)
				B132 (folder)
				B264 (folder)

Prior to install, disconnect network connections, Fax lines and any Fiery 
Controller interface cables.

Refer to the Firmware Update Procedure in the Service Manual to determine if 
the Front Cover of the machine should be open or closed during the update 
(some models require the front cover open to reduce electrical noise).  Additionaly, 
follow any machine specific instructions.

Never connect or remove the SD Card with the machine power on.

Some firmware takes time to load.  Do Not power off until machine completes 
update.  Do not leave the machine unattended.

If a power failure occurs during the firmware update procedure, turn the machine 
power off / on without removing the SD Card.  The firmware update procedure 
should start again.

If E32 or E44 are displayed.  Refer to Pub Bulletin 81 for details.